Entering An Ip Card Number And Password - UTStarcom UTS 801 User Manual

3-10 Other Essential Functions

3.7 Entering an IP Card Number and Password

This function allows you to enter an IP/200/300 card number and password
in the memory of the phone, which can be dialed via the
Κ
Note: The settings of IP card number and password may be different due to
different service terminals. Therefore, the card number and password must
be set accordingly.
1. Press and then
password on the LCD of the phone as shown in the figure below.
If no IP card number and password have been entered then
"F5 IP no" will be displayed on the LCD.
2. Press to enter the edit mode.
If the IP card and password exceeds 13 digits, only the first
13 digits are shown in the LCD display. The phone will
automatically flash the remaining digits every one-second.
3. Press key to
and Password (Maximum of 24 digits).
When the first digit is entered, the current IP card number
password will be erased.
If the IP card number and password entered is more than 16
digits, only the last 16 digits will be displayed.
To cancel and exit, press
screen.
4. To save the IP card number and password, press the
phone sounds a beep and the new IP card number and password
is displayed.
5. To exit and return to standby mode press
to display the current IP card number and
on the dial pad to enter the IP card number
to return to the previous
801 (FSU) User Manual
key
key. The
.