Pause" Function - UTStarcom UTS 801 User Manual

801 (FSU) User Manual
Κ
Note: The IP card number and password must be entered into the phone
prior to using the
Κ
Note: Refer to setting IP card number and password. Refer to "Entering an
IP number and Password."

2.1.2 "Pause" Function

This function allows you to add a delay between the digits of a phone
number when the phone dials it.
Κ
Note: Pause " " cannot be the first characters of the dialing string (phone
number).
Κ
Note: Using Pause more than once increases the length of delay between
the numbers. The number following the second pause " " will be
automatically dialed.
3. Select the appropriate language. When you are asked to enter the
IP card number and password press the
automatically send the IP card number and password stored in
memory. The numbers will scroll from right to left across the
LCD display as shown in the figure above.
4. If the call is successfully completed, follow the instructions from
your service provider.
5. To end a call, hang up the handset.
key.
1. Pick up the handset (off-hook).
2. Dial the first part of the phone number. Press and hold down
for 2 seconds, the pause symbol " " will displayed as
shown in the figure below.
3. Dial the second part of the phone number.
4. Press or wait three seconds for the first part of the phone
number to sent out to the network. Wait for the call to be
answered then press
number.
Basic Operations 2-3
key. The phone will
to send the second part of the phone