Optional Ash Cleanout System; Disposal Of Ashes; Baffle Removal; Removal - Pacific energy SUPER CLASSIC Operating And Installation Instructions

Optional Ash Cleanout system:

The ash dump handle is located under the ash lip on the left hand side. To operate ash dump, pull handle
out 1/2"(13mm) and turn clockwise. This will unlock the ash dump and allow it to open. Hold handle open
while pulling ashes into the opening. Avoid large embers as these still contain heat value. Release handle and
push in to lock. Ensure ash dump door is properly engaged. Fill the cavity with the remaining ash level with
the firebox floor. Lift and pull out ashpan and discard ashes into metal container. Replace ashpan and ensure
it is seated properly.
Do not burn with ash dump door open. Doing so will create a hazardous condition. Always leave about
1"(25mm) of ash when cleaning.

Disposal of Ashes

Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should
be placed on a non-combustible floor or on the ground, well away from all combustible materials, pending
final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be
retained in closed container until all cinders have thoroughly cooled. Other waste should not be placed in this
container.
Chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible
should you remove baffle assembly.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.

Removal

Remove retaining pin at the back top of the firebox, just under the baffle. Lift baffle up and pull forward to
disconnect from the supply tube. Tilt baffle sideways to drop down and remove from firebox. Inspect gasket
between baffle and supply tube. If necessary, replace with gasket #139.5 available from your Pacific Energy
dealer. Re-install baffle assembly in reverse order. The two side pieces of insulation must be tight against the
siderails.
SUPER-SD1_100517-32

Baffle Removal

21
5055.201