Working with Files
Cell Data Listed For Each Cell
•
VOLT shows the cell voltage
•
RES shows the cell resistance
•
Int R1 shows the Intercell resistance R1
•
Int R2 shows the intercell resistance R2
•
Int R3 shows the intercell resistance R3
•
Int R4 shows the intercell resistance R4
•
Specific Gravity shows the specific gravity
•
Temp shows the temperature
Set the thermal printer power switch to ON. If the Status LED is on, connect the printer charger. A
flashing Status LED means high temperature or paper out. Refer to the printer manual for more
information.
CAUTION: Charge the printer's battery with the printer's power off. The printer cannot operate
from the charger. Minimum charge time is one hour. Do not leave the charger connected; this will
shorten battery life. To begin to print to the thermal printer, press Shift then F1.
On the Select Headers LCD window, select items for the report: site information, statistics, faults, and
thresholds. Press Next/F2, Select Data you want included, then press Next/F2,
Note: Use the arrows to highlight an item, then press Enter to select or unselect it.
Select Headers
Select Data
Place PC/Printer
Align the Cellcorder and printer IR ports, and press Continue/F1. The printer Status LED flashes while
data is being received.
590-2099-501A/SL-29414/4200-070
15- 19
Revision 4