Balluff Network Interface EtherNet/IP™
3
Getting Started
3.2. Mechanical
connection
3.3. Electrical
connection
Power Supply
Grounding
Ethernet IP
Interface
www.balluff.com
The module is attached using 2 M6 screws and 2 washers.
Isolation pad as accessory available
Pin
1
+24 V
2
+24 V
3
0 V
4
0 V
Note
Provide sensor/bus power and actuator power from separate power sources if
possible.
Total current <9A. The total current of all modules may not exceed 9A even
when daisy chaining the actuator supply.
Note!
The FE connection from the housing to the machine must be low-impedance
and kept as short as possible.
M12, D-coded, female
Pin
Function
Function
1
Tx+
2
Rx+
3
Tx-
4
Rx-
Description
Output Power
Input Power
Input Power Common GND
Output Power Common GND
6