Key Digital KD-DA2x8G Operating Instructions Manual page 15

KD-DA2x8G Help Command (H). Returns entire API in readable format:
--------------------------------------------------------------------------
-
-------------------------------------------------------------------------
-- KD-DA2x8
--
-- Azz : All Commands may have Prefix System Address zz=[01-99] --
-- H : Help
-- PF : Power Off
-- PN : Power ON
-- STA : Show Global System Status
--
-- Video Output Setup Commands: xx = [01-08], yy = [01-02,U/D]
-- SPO SI yy
-- SPO01 SI yy
--
-- SPO xx ON/OFF
-- SPO xx DBG ON/OFF : Set Output xx Debug Mode ON/OFF
--
-- Audio Output Setup Commands: [E=Enable, D=Disable]
-- SPO AA E/D : Enable/Disable External Analog Audio Output
-- SPO DA E/D : Enable/Disable External Digital Audio Output
--
-- Input/Output/Device naming Commands xx=[01-08], <Max. 16 Chars>
-- SPI xx WN cccccccccccccccc : Write Input xx Name
-- SPI xx RN
--
-- SPO xx WN cccccccccccccccc : Write Output xx Name
-- SPO xx RN
--
-- SPC WN cccccccccccccccc : Write Device Name
-- SPC RN
--
--
-- Network Setup,
-- SPCETIPA xxx.xxx.xxx.xxx : Set Host IP Address to xxx.xxx.xxx.xxx
-- SPCETIPM xxx.xxx.xxx.xxx : Set Net Mask to xxx.xxx.xxx.xxx
-- SPCETIPR xxx.xxx.xxx.xxx : Set Route IP Address to xxx.xxx.xxx.xxx
-- SPCETIPP zzzz
-- SPCETIPB
--
-- System Address Setup Command: xx = [00-99], 00 = Single
-- SPC Axx : Set System Address to xx
--
-- System Control Setup Commands:
-- SPC AS x : Set Auto Sense Mode x = [0:OFF,1:AUTO,2:FORCED ON]
-- SPC FB E/D : Enable/Disable Front Panel Buttons
-- SPC FHPD ON/OFF: Set Forced HPD ON/OFF
-- SPC RSB z : Set RS232 Baud Rate to z bps, z=[0-4]
-- [0:57600, 1:38400, 2:19200, 3:9600, 4:4800]
-- SPCDF : Reset to Factory Default All
-- SPCDF00 : Reset to Factory Default without Network Reset
-------------------------------------------------------------------------
Key Digital Systems HELP
System Address = 00
: Set Output to Video Input yy
: Set Output to Video Input yy
: Set Output xx ON/OFF
( xxx=[000-255], zzzz=[0023~9999] )
: Set TCP/IP Port to zzzz
: Apply New Network Config
F/W Version : 1.11
: Read Input xx Name
: Read Output xx Name
: Read Device Name
13
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--