Workzone Titanium CS20V Instruction Manual page 7

h). Keep handles and grasping surfaces dry, clean and free from oil and
grease. Slippery handles and grasping surfaces do not allow for safe
handling and control of the tool in unexpected situations.
5) Battery tool use and care
a). Recharge only with the charger specified by the manufacturer. A charger
that is suitable for one type of battery pack may create a risk of fire when
used with another battery pack.
b). Use power tools only with specifically designated battery packs. Use of
any other battery packs may create a risk of injury and fire.
c). When battery pack is not in use, keep it away from other metal objects,
like paper clips, coins, keys, nails, screws or other small metal objects,
that can make a connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
d). Under abusive conditions, liquid may be ejected from the battery; avoid
contact. If contact accidentally occurs, flush with water. If liquid contacts
eyes, additionally seek medical help. Liquid ejected from the battery may
cause irritation or burns.
e). Do not use a battery pack or tool that is damaged or modified. Damaged
or modified batteries may exhibit unpredictable behaviour resulting in fire,
explosion or risk of injury.
f). Do not expose a battery pack or tool to fire or excessive temperature.
Exposure to fire or temperature above 130 °C may cause explosion.
g). Follow all charging instructions and do not charge the battery pack or
tool outside the temperature range specified in the instructions.
Charging improperly or at temperatures outside the specified range may
damage the battery and increase the risk of fire.
6) Service
a). Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
b). Never service damaged battery packs. Service of battery packs should
only be performed by the manufacturer or authorized service providers.
AFTER SALES SUPPORT
1300 889 028 (toll free)
12
e-mail: info.aldi@positecgroup.com
MODEL No.: CS20V • 63350 • 01/2019
Additional safety rules for circular saws
WARNING! The warnings, precautions, and instructions discussed in
this manual cannot cover all possible conditions and situations that
may occur.
The operator must understand that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
DANGER
a. Keep hands away from cutting area and the blade.
If both hands are holding the saw, they cannot be cut by the blade.
b. Do not reach underneath the workpiece. The guard cannot protect you
from the blade below the workpiece.
c. Adjust the cutting depth to the thickness of the workpiece. Less than
a full tooth of the blade teeth should be visible below the workpiece.
d. Never hold the workpiece in your hands or across your leg while cutting.
Secure the workpiece to a stable platform. It is important to support the
work properly to minimise body exposure, blade binding, or loss of control.
e. Hold the power tool by insulated gripping surfaces, only when
performing an operation where the cutting tool may contact hidden
wiring or its own cord. Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and could give the operator an electric shock.
f. When ripping always use a rip fence or straight edge guide. This
improves the accuracy of cut and reduces the chance of blade binding.
g. Always use blades with correct size and shape (diamond versus
round) of arbour holes. Blades that do not match the mounting
hardware of the saw will run off-centre, causing loss of control.
h. Never use damaged or incorrect blade washers or bolt. The blade
washers and bolt were specially designed for your saw, for optimum
performance and safety of operation.
AFTER SALES SUPPORT
1300 889 028 (toll free)
13
e-mail: info.aldi@positecgroup.com
MODEL No.: CS20V • 63350 • 01/2019