Workzone Titanium CS20V Instruction Manual page 13

Making a Pocket Cut
1. Adjust the depth of cut as required per previous instructions
2. Adjust the bevel setting to 0°.
3. R
so the blade (21) does not touch the work piece (Fig R).
4. With the blade (21) just clearing the work piece, start the motor by depressing
5. Always let the blade reach full speed (approximately 2 seconds) before you
begin to cut into the work piece.
6. Slowly lower the circular saw into the work piece, using the front of the base
resting on the work piece as a hinge point.
WARNING. As soon as the blade starts cutting the material, release the
lower blade guard lever (13).
7. Onc
forward direction to the end of the cut.
8. After completing your cut, release the trigger switch (4) and allow the blade (21)
to come to a complete stop.
Do not remove the circular saw from the work piece while the blade (21) is
moving.
NOTE: If the corners of your pocket cut are not
completely cut through, use a jigsaw or hand saw
.
AFTER SALES SUPPORT
1300 889 028 (toll free)
R.
24
e-mail: info.aldi@positecgroup.com
MODEL No.: CS20V • 63350 • 01/2019
Circular Saw Cutting Tips
Always hold the main handle (7) with one hand and the front handle (8) with the
Never force the circular saw. Use continuous and light pressure. If cutting is
and squeeze the trigger switch (4). Allow the blade (21) to reach full speed,
re-enter the cut slowly and resume with cutting.
of the wood may have a tendency to tear and lift. Pushing the saw slowly will
Changing the Blade
WARNING:
the battery (27) is removed before making any adjustments.
1. P
2. Rotate the saw blade (21) by hand whilst depressing the spindle lock
button (20) until the blade locks (Fig S).
3. Whilst depressing the spindle lock button (20), turn the blade bolt
anti-clockwise using the supplied allen key (2) (Fig T).
4. R
5. Raise the lower blade guard (14) using the blade guard lever (13).
6. R
and away from the circular saw (Fig U)
NOTE: We recommend wearing gloves when removing the blade (21).
7. Clean the sa
will touch the blade.
AFTER SALES SUPPORT
1300 889 028 (toll free)
inner blade flange
25
e-mail: info.aldi@positecgroup.com
MODEL No.: CS20 • 63350 • 01/2019