Table of Contents
Advertisement
pBS11004 Base Station Installation Guide
open the wiring cavity.
2.
Connect the Ethernet cable to ETH interface in the wiring cavity.
3.
Lay Ethernet cable along the wire groove, and stretch out the wiring cavity from ETH
hole.
4.
The other end of the Ethernet cable connects to the PoE power adaptor.
4.3.2 Connect Ground Cable
Make the grounding cable according the actual situation of the installation site.
The grounding screws of pBS11004 located on the bottom of the base station, as shown
in Figure 4-1.
Figure 4-1 Location of Grounding Screws
1.
Unscrew the grounding screw, connect one end of the grounding cable to the
grounding screw, and fasten it again.
2.
The other end of the ground cable needs to connect to a good grounding point.
12
Advertisement
Table of Contents
