Table of Contents
Advertisement
3. Prior to use
Step 1: Open the Valve(s)
Open the valve(s) of the external fuel tank.
Step 2: Start the Fuel flow
If using heater for the first
time, or after heater has
been out of fuel, press the
red reset button once for a
period of one second in
order to send fuel to the fuel
sump.
Note: Make sure there is no fuel leakage from the
fuel line or joints.
Also make sure fuel tank is not too high. See
installation instructions.
Step 3: Set the top guard
The top guard is in the
carton box. Please take it
out from the box, and set it
on the top plate of the heater
before using it to prevent a
fire.
Step 4: Plug in the heater
Insert the plug into the wall-socket (220 Volts –
AC/50Hz).
Step 5: Setting the clock
Important: The clock on the heater must always be
set to the correct time.
It is only possible to set the correct time, when the heater
is connected to the mains and not burning.
Use the adjustment buttons to set the time.
First press either of the two buttons to switch on the
function "empty full"(the CLOCK light and the information
display will start blinking). Next, set the hours using the
button on the left (-HOUR) and the minutes using the
button on the right (+MIN.). Press once to increase the
value by one step. When you hold down the button, the
value will continue going up, until you release the button
again. After approximately 10 seconds the blinking will
stop and the setting will be locked. After switching off the
heater, the clock time will be displayed.
Reset Button
6
Advertisement
Table of Contents
