Table of Contents
Advertisement
6.
Secure the L-shaped hose to the intake inlet opening with the hose band. Secure the bent joint to the flue pipe
with the pipe holder (If the extension pipe is used, also attach the pipe holder to the connection of the bent
joint and the extension pipe). Secure the bent joint (or the extension pipe) to the exhaust outlet opening by
sliding the pipe stopper in the exhaust opening bracket (See Fig. 8).
7. Make sure the position of the heater is level by using the plumb bob located at the right side of the heater. The
plumb bob weight should be within the circle. If the plumb bob weight is not within the circle, adjust the heater
legs until the plumb bob weight is within the red circle (See Fig. 9 & 10).
Good
Weight
Circle
Bad
Plumb bob as viewed from above
Fig. 9
Pipe Stopper
Pipe holder
Fig. 8
Fig. 10
20
Advertisement
Table of Contents
