G1. Simple Troubleshooting Tips - WANHAO MARK II Duplicator 6 Plus User Manual

G1. Simple Troubleshooting tips

In case something goes wrong with your D6, the following
chapter will help you. From diagnosing and fixing the problem yourself
to contacting support.
Print detaches during printing or print does
not stick at all.
Cause
Build plate is not properly leveled.
Solution
Follow the instructions under [MAINTENANCE]
and then [Auto bed leveling]
Solution
Use a spatula or another thin object such as a
wedge between the glass and the object. Slowly
push the wedge under the object from different
directions. If the object will not
release from the build plate try slightly tapping
the wedge.
Material feeder ticks when loading
new material Cause
Material has reached the nozzle and is exiting the nozzle, the feeder cannot keep up
with the flow.
Solution
While loading new material it is normal for the feeder to tick, the feeder is designed
to tick backwards instead of grinding the material.
37
G1. Simple Troubleshooting tips Troubleshooting and support for the D6 Plus
Caution: be very careful when using a sharp
tool to remove objects.