E1. Downloading And Installing Cura - WANHAO MARK II Duplicator 6 Plus User Manual

E1. Downloading and installing Cura

The preferred software for your D6 is Cura from wanhao.
This software package prepares your 3D model into instructions that
your D6 uses to produce an object.
1. The Cura software package can be downloaded
from the "Down load " section on our website:
http://www.wanhao3dprinter.com/Down/ShowArticle.
asp?ArticleID=56
2. Download the latest version of Cura for your operating system. Our software is
available for, WindowsXP or newer, MacOS 10.6 or newer and Ubuntu Linux 12.10
or newer.
3. Open the installer and follow the directions to install the software.
4. After installing Cura, Cura will ask
what kind of 3D printer you have.
Select the D6 Plus. No other
configuration will be required, and
Cura will be ready to use.
5. After the installation you will see
the D6-robot positioned in the
Cura interface.
E1. Downloading and installing Cura Make a printfile with cura software
NOTE: We keep on updating our software, so the
latest version that you have downloaded might be a
newer version than the one in this manual.
26