F3. Lubricating The Axes - WANHAO MARK II Duplicator 6 Plus User Manual

F3. Lubricating the axes

Z-Axis
After approximately every half year the
threaded rod on the z-stage has to be
lubricated. A green grease (Magnalube-G) is
included with the D6. This grease is
the lubrication which has to be used on the
threaded Z-stage rod.
Note: the green grease should be applied as is
shown in the photograph.
Make sure you spread 10 drops of grease over
the entire exposed threaded rod. With you next
print on the D6 Plus the Thread will grease
itself by moving up and down.
X-Y-Axes
If you notice small wavers in the outside
surfaces of your 3D printed objects.
It is recommended
to add a single drop of sewing machine
oil onto the X and Y steel axes bars.
This will inprove the smooth movement
of your D6 Plus. This lubrication
is not included in the D6 Plus package.
If you choose to lubricate the X- and Y-axis you
MUST use sewing machine oil. Apply a maximum of one
droplet oil on the axis.
Remove any excess oil.
35
F3. Lubricating the axes Maintenance for your D6 Plus