Charge Battery - Siemens S46 User Manual

6.11.01 S46 US DRAFT
14

Charge battery

The battery is not fully charged
when delivered. You should there-
fore:
• Plug in charger cable at the bot-
tom of the phone and plug in the
power supply unit to the power
supply (only use the charger sup-
plied; charge for at least two
hours).
• Push the sides of the charger ca-
ble plug together and pull to re-
move it.
Charging
The following is shown at the top of the dis-
play:
When charging is in progress.
End of charging.
An empty battery is fully charged after
about 2 hours. Charging is only possible in
an ambient temperature of 5°C to 40°C
(the charge icon flashes as a warning when
the temperature is 5°C above/below). The
voltage specified on the power supply unit
must not be exceeded.
A31008-H5450-A5-*
Getting Started
Standby time
A fully charged battery provides
hours of standby time or
of talk time. The standby times/talk times
are average values and depend on the op-
erating conditions (see table below).
Charge level display (fully charged to emp-
ty):
A beep sounds when the battery is nearly
empty.
Battery totally discharged
If your mobile phone will not switch on and
no charge icon is displayed when you plug
in the charger, it may be that the battery is
totally discharged and has to be reactivat-
ed.
If this is the case, leave the charger cable
plugged in. The charge icon will appear af-
ter a maximum of 2 hours. The battery is
then automatically recharged.
Decrease of standby time
Operation car-
ried out
Callingl
Display back
light *
Network search
* key input, games, organizer etc.
60 to 300
100 to 360 minutes
Time Decrease of
(min) tstandby time
1 30 to 60 minutes
1 30 minutes
1 5 to 10 minutes