Charge Battery - Siemens S55 Operating Instructions Manual

8

Charge battery

The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains pow-
er socket and charge for at least two
hours.
Display when charging is in progress
h
During charging.
Charging time
An empty battery is fully charged af-
ter about 2 hours. Charging is only
possible within the temperature
range 5 °C to 40 °C. At both 5 °C
above or below, the charge icon
blinks as a warning. The mains volt-
age specified on the power supply
unit must not be exceeded.
To obtain maximum performance
from the battery it must be fully
charged and then emptied at least
five times.
Note
Your phone's display is delivered with a protective film.
Remove this film before getting started.
In rare cases the static discharge may cause discolouration at the edges of the display.
However this will disappear within 10 minutes.
Getting started
Charge icon not visible
If the battery is totally discharged, no
charge icon is displayed when the
charger is plugged in. It will appear
after two hours at most. In this case
the battery is fully charged after
3-4 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty-full):
A beep sounds when the battery is
nearly empty. The battery level is on-
ly shown correctly during an unbro-
ken charging/discharging cycle. You
should therefore not remove the bat-
tery unnecessarily and where possible
not finish the loading process early.
a d g
Note
The charger heats up when used for long
periods. This is normal and not dangerous.
Performance...............................page 116
Battery quality statement............page 112