See Also Charge Battery - Siemens M56 User Manual

M56 Barracuda long, am english, A31008-H6350-A40-1-4A19 (28. July 2003,
16
Charge battery
The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains
power socket and charge for at
least two hours.
Display when charging is in progress
During charging.
Charging time
An empty battery is fully charged
after about 2 hours. Charging is only
possible within a temperature range
of +41 °F–104 °F. If the temperature
rises/falls 41 °F above/below this, the
charge symbol flashes a warning.
The mains voltage specified on the
power supply unit must not be
exceeded.
Note
Your phone's display is delivered with a protective film.
Remove this film before getting started.
Electrostatic charging can in rare cases lead to discoloring at the edge of the display. This
will, however, disappear of its own accord after 10 minutes at the most.
Getting started
Charge symbol not visible
If the battery has been discharged
fully the charge icon is not visible
when the charger is plugged in. It
will appear after up to two hours. In
this case the battery is fully charged
after 3–4 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty-full):
A beep sounds when the battery is
nearly empty. The battery level is
only shown correctly during an
unbroken charging/discharging
cycle. You should therefore not
remove the battery unnecessarily and
where possible not finish the charging
process early.
Additional information
The charger heats up when used for long
periods. This is normal and not dangerous.
Operating time.................................p. 118
Outside your home network ............p. 118