Verifying Your Panopto Settings - Matrox Maevex 6020 User Manual

Assigning a static IP address to your device
By default, your Matrox device is configured to use a
manually assign a static IP address to your device through the network settings of your
Maevex product.
1 Select
IPv4 address
gateway
Maevex device.
When you're done, click
2
For your devices to be detected, you
may need to search for the devices
again.
More information on network settings
IPv4 address
(recommended). Also, we recommend you assign an IP address within the subnet of
your network.
IPv4 netmask
default, the subnet mask is 255.255.255.0.
IPv4 gateway
be 0 or 1.
DNS servers
you're entering multiple addresses, separate each address with a space.
For more information on assigning a static IP address, contact your network administrator.

Verifying your Panopto settings

Sign in to the Panopto server as an administrator.
1
2 Click
System
For more information, go to http://support.panopto.com, search for remote recorders, and look for
the article titled Remote Recorder Configuration and Quality Settings.
After configuring your Maevex remote recorder, you can start recording
recordings", page
, then specify the
Static IP address
,
IPv4 netmask
, and for your
DNS servers
Apply
– An IP address between 192.168.0.0 and 192.168.255.255
– The subnet mask defining group of IP addresses in your subnet. By
– The gateway is often the same as your IP address, but the last byte may
– The address of your DNS (Domain Name System) server or servers. If
Remote Recorders
26).
Dynamic IP address (DHCP)
,
IPv4
.
, then configure your remote recorder settings.
Matrox Maevex 6020 Remote Recorder – User Guide 25
. You can
(see "Managing your