Configuring Your Maevex Remote Recorder; Before You Begin; Assigning An Ip Address Or A Host Name - Matrox Maevex 6020 User Manual

Configuring your Maevex remote
recorder
This section describes how to configure and update your Matrox Maevex remote recorder.

Before you begin

Make sure you connect your product before configuring it. For more information on
connecting your product,
You may need administrator rights to install or uninstall certain software. For more
information, see Windows documentation or contact your system administrator.
Make sure you have an NTP (Network Time Protocol) server. For more information,
contact your network administrator.
Make sure you have a Panopto account. For more information, contact your Panopto
administrator.
Windows Server 2016, Windows Server 2012, and Windows Server 2012 R2 – Make sure
the SSDP Discovery service, network discovery, and file sharing options are enabled.
Make sure you're using the Matrox Maevex 6020 Configuration and Firmware Utility on
a system that's running Microsoft® Windows®.
Make sure you have a recorder registration key from Panopto. For more information,
"Obtaining a registration key for your remote recorders", page

Assigning an IP address or a host name

To locate a remote recorder, Matrox software uses the device IP addresss through UPnP or the host
name through a DNS server. For more information on which network protocol you should use
contact your network administrator.
see "Connecting your Maevex remote recorder", page
Matrox Maevex 6020 Remote Recorder – User Guide 17
9.
see
18.