Freedom X Owners Guide.book Page 36 Wednesday, May 11, 2016 10:32 AM
Marine Installation
To install the drip shields:
1.
Gather the four screws needed to fasten a single drip shield to a
wall.
2.
Locate an appropriate setting for the drip shields above the
Freedom X making sure you cover the entire width of the unit.
You can overlay the shields as shown in Figure 9 below.
3.
Fasten the screws through the holes in the drip shield into the
wall. See Figure 8.
Figure 9 Typical Drip Shield Placement on a Freedom X
36
Freedom X Owner's Guide