Description Of Ignition Control Features; Ignition Signal (Acc) Input Terminal - Xantrex Freedom X 1200 120VAC Owner's Manual

Freedom X Owners Guide.book Page 31 Wednesday, May 11, 2016 10:32 AM
ACC input (Ignition
signal input) terminal
ignition control wire
Figure 6 Ignition Signal (ACC) Input Terminal
5. Using a 3mm slot long neck screwdriver, loosen the screw
without removing it.
6. Insert the ignition control wire into the ACC input terminal slot.
7. Tighten the screw to secure the wire.
NOTE: The mechanical elements of the ACC input terminal
including the switch shown in Figure 6 work in conjunction with the
Ignition Control features set separately from the display panel.
975-0767-01-01

Description of Ignition Control Features

Ignition Control
For information about the features and instructions on changing the
switch
ignition control features, see "To change the inverter Ignition
Control feature:" on page 43.
Ignition Auto-
on ()
Ignition Lock-
out ()
Off ()
Basic Installation Procedures
This setting allows the inverter to operate (Battery
mode) automatically when an ignition control wire is
connected to the ACC input and a valid ignition
signal is constantly detected. The inverter works in
tandem with the vehicle's ignition circuit.
The ignition control switch on the front of the unit
must be ON (|) to enable this feature.
This setting allows the inverter to operate (Battery
mode) when an ignition control wire is connected to
the ACC input terminal and a valid ignition signal is
constantly detected. The ignition control switch on
the front of the unit must be ON (|) to enable this
feature.
When enabled, you have to manually press the
inverter Power button on the display panel to operate
the inverter.
To completely disable the ignition control features do
the following:
1. Set Ignition Control to Off () using the Select
buttons on the Display panel (see page 43).
2. Turn the ignition control switch to OFF (O) from
the AC Panel of the unit ( see page 4).
31