Switching The Input Mode; Adjusting The Volume - Sharp Notevision PG-B10S Operation Manual

Switching the INPUT
Mode
Select the appropriate input mode for the con-
nected equipment.
Press , or
control to select the INPUT mode.
When pressing on the projector, input
mode switches in order of
INPUT 1 INPUT 2 INPUT 3
Note
When no signal is received, "NO SIGNAL"
will be displayed. When a signal that the
projector is not preset to receive is received,
"NOT REG." will be displayed.
The INPUT mode is not displayed when
"OSD Display" of the "Options" menu is set
to "OFF". (See page 41.)
About the INPUT mode
INPUT 1 Used for projecting images from
(RGB/ equipment that sends RGB sig-
Component) nals or component signals con-
nected to the RGB input terminal.
INPUT 2 Used for projecting images
(S-Video) from equipment connected to
the S-VIDEO input terminal.
INPUT 3 Used for projecting images
(Video) from equipment connected to
the VIDEO input terminal.

Adjusting the Volume

Press or on the remote con-
trol to adjust the volume.
Note
Pressing will lower the volume.
Pressing will raise the volume.
On the projector, the volume can be ad-
justed by pressing
on the remote
.
or .
"On-screen Display of INPUT Mode (Example)
INPUT 1 mode
Using RGB
Using
Component
INPUT 2 mode
Using S-Video
INPUT 3 mode
Using Video
INPUT buttons
Volume buttons
-19