Turning The Power Off (Putting The Projector Into The Standby Mode) - Sharp Notevision PG-B10S Operation Manual

2
Press ', ", \ and | to adjust
the Keystone Correction.
You can also adjust the Keystone Cor-
rection using the
buttons on the projector.
Note
Press to return to the default setting.
Straight lines or the edges of images may
appear jagged while adjusting the image.
3
Press .
The on-screen display of the Keystone
Correction mode will disappear.
You can also use
Note
You can use the same settings used in
NORMAL mode 4:3 for 16:9.
Turning the Power off
the Projector into the Standby Mode)
1
Press on the projector or
STANDBY
on the remote control, then
press that button again while the
confirmation message is dis-
played, to put the projector into
the standby mode.
Note
If you accidentally pressed
STANDBY
or and do not want to put the pro-
jector into the standby mode, wait until
the confirmation message disappears.
2
Unplug the power cord from the AC
outlet after the cooling fan stops.
Info
Do not unplug the power cord during pro-
jection or cooling fan operation. The cool-
ing fan in this projector continues to run
for about 90 seconds after the projector
enters the standby mode. This can cause
damage due to rise in internal tempera-
ture, as the cooling fan also stops.
, , and
on the projector.
(Putting
Compresses
upper side.
Compresses
lower side.
STANDBY
button
-21