Switching The Input Mode; Adjusting The Volume; Input Buttons; Volume Buttons - Sharp Notevision PG-MB60X Operation Manual

Switching the INPUT
Mode
Select the appropriate input mode for the con-
nected equipment.
Press , ,
mote control to select the input mode.
' ' ' ' or " " " " " on the projector, input
• • • • • When pressing '
mode switches in order of :
INPUT 1 INPUT 2
Note
• When no signal is received, "NO SIGNAL"
will be displayed. When a signal that the
projector is not preset to receive is received,
"NOT REG." will be displayed.
• The INPUT mode is not displayed when
"OSD Display" of the "Options1" menu is set
to " " (OFF). (See page 50.)
About the INPUT mode
INPUT 1/ Used for projecting images from
INPUT 2 equipment that sends RGB sig-
(RGB/ nals or component signals con-
Component) nected to the RGB input terminal.
INPUT 3 Used for projecting images
(Video) from equipment connected to
the VIDEO input terminal.
INPUT 4 Used for projecting images
(S-Video) from equipment connected to
the S-VIDEO input terminal.

Adjusting the Volume

Press \ \ \ \ \ /| | | | | on the projector or VOL
/ on the remote control to ad-
just the volume.
Note
or \ will lower the volume.
• Pressing
or | will raise the volume.
Pressing
or on the re-
INPUT 3 INPUT 4
"On-screen Display of INPUT Mode (Example)
INPUT 1/2 mode
Using RGB
Using
Component
INPUT 3 mode
Using Video
INPUT 4 mode
Using S-Video
"On-screen Display
/ / /

INPUT buttons

Volume buttons

-33