Table of Contents
Advertisement
Reinstalling a storage enclosure
Attention:
is installed and closed or a storage enclosure is installed. Do not attempt to
override this protection.
To reinstall a storage enclosure, complete the following steps:
1. Orient the storage enclosure above the system-board tray.
2. Lower the storage enclosure so that the pins at the rear slide down into the
3. If you disconnected cables when you removed the storage enclosure, reconnect
4. Pivot the storage enclosure down onto the system-board tray until it clicks into
5. Install the system-board tray in the chassis (see "Reinstalling a system-board
You cannot install the system-board tray in the chassis until the cover
Expansion
enclosure
slots at the rear of the system-board tray. Before you close the storage
enclosure, make sure that all components are installed and seated correctly, all
internal cables are correctly routed, and you have not left loose tools or parts
inside the system-board tray.
them.
place.
tray in a 2U chassis" on page 32).
System-board
tray
Chapter 3. Installing optional devices
31
Advertisement
Table of Contents
