IBM System x iDataPlex dx360 User Manual page 36

10. Carefully grasp the adapter by the top edge or upper corner and insert it in the
11. Follow the cabling instructions, if any, that come with the adapter. If possible,
12. Pinch the two sides of the one-slot riser card, and align the riser card with the
13. Install the riser card retaining screw at the front of the system-board tray.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 30.
24
IBM iDataPlex dx360 User's Guide
Note: If an adapter is already installed in the riser card, the riser card and
adapter are removed together.
6. Carefully grasp the one-slot riser card by its top edge or upper corners, and
pull the riser card straight up and out of the system-board tray.
7. Carefully set the riser card on a flat, static-protective surface. If an adapter is
installed in the riser card, remove it.
8. Touch the static-protective package that contains the adapter that you are
installing to any unpainted metal surface on the system-board tray; then,
remove the adapter from the static-protective package. Avoid touching the
components and gold-edge connectors on the adapter.
9. Follow the instructions that come with the adapter to set any jumpers or
switches.
one-slot riser card. Align the adapter with the riser card connector; then, press
the adapter firmly into the connector.
Note: Make sure that the adapter is inserted correctly. Improper installation of
an adapter might damage the PCIe riser-card assembly or the adapter.
route the adapter cables before you install the adapter.
riser-card connector on the system board; then, press the riser card firmly,
evenly with both hands, into the connector.