IBM System x iDataPlex dx360 User Manual page 41

8. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the system-board tray. Then, remove the new DIMM from the
package.
9. Turn the DIMM so that the DIMM keys align correctly with the connector.
10. Insert the DIMM into the connector by aligning the edges of the DIMM with the
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on the top of the DIMM at both ends
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector. If there is a gap between the DIMM
and the retaining clips, the DIMM has not been correctly installed. Open the
retaining clips, remove the DIMM, and then reinsert it.
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 30.
Chapter 3. Installing optional devices
29