Mitsubishi MELSEC L Series User Manual page 378

Errors
Program example
17 - 31
When the dedicated instruction is completed with an error, the status display device at
completion ((D)+1), turns on and the error code is stored in the control data
registration/deletion result ((S1)+1).
See the following manuals regarding the error code, and check the errors and take
corrective actions.
<Error codes>
4FFF or less : User's manual (hardware design, maintenance and inspection) for the
H
CPU module used
7000 or higher: User's Manual (Basic)
H
The following shows an example of a sequence program when registering user frames.
Data set for the program example are as follows:
Setting item
User frame No.
Registration data (10 bytes)
When the input/output signals of the Q series C24 are X/Y80 to X/Y9F
Setting data
3E8
H
Binary 46 ,39 ,30 ,30
H H H
ASCII F90000FF00
17 DEDICATED INSTRUCTIONS
,30 ,30 ,46 ,46 ,30 ,30
H H H H H H
Registration request
Sets the registration request
Sets the frame number to be registered
Sets the number of registration data bytes
Sets the registration data for the frame to be
registered in D4 to D8
Sets the flash ROM write allow
Executes user frame registration
Normal completion
Abnormal completion
H
17- 31