Coupon Configuration Selection Screen; Process Selection Screen - Lincoln Electric VRTEX 360+ Operator's Manual

VRTEX 360+, VRTEX 360, VRTEX
® ®
1. USB Indicator
The circular USB icon in the upper right corner of the screen indicates
the presence of a USB memory stick in the front of the machine.
Translucent: no USB stick connected, Green: USB connected and
ready, RED: writing data (do not remove).
2. Theory Screen
The theory icon has been implemented to assist users with additional
content, images and information related to the area of the application
where you are working. See Figure 42. This information can be
accessed by selecting the yellow theory icon. When selected, the
icon allows the student to access visual and definitional information
about the different welding terms being used on each screen.
Welding terms that correspond with each page are listed in the boxes
on the left-hand side of the screen. When finished reviewing the
theory data, the student can select the theory icon again to exit the
screen.
Figure 42 – Theory screen
COUPON CONFIGURATION
SELECTION SCREEN
OVERVIEW
The user selects which coupon configuration they want to virtually
weld. (Red arrows change material type). See Figure 43.
Figure 43 – Joint configuration screen
TRANSPORT
®
21
PROCESS SELECTION
SCREEN
OVERVIEW
This screen allows the user to select the welding processes. See
Figure 44. To change among VR GMAW, VR FCAW and VR SMAW,
the user touches the desired processes. If a process is not supported
for the selected material/thickness, it will not appear on this screen
and cannot be selected. To choose among different sub-processes,
touch the appropriate icon.
At the top of the screen, the user can see the coupon position and
thickness selected. As the user continues to set up the simulation,
additional information will be added to the right of this readout so that
the user can reference what has previously been selected.
Figure 44 – Process selection screen
TABLE SETUP SCREENS
OVERVIEW
Figure 45 – Table setup screen
The correct VR table information must be selected for the VRTEX to
operate properly in all virtual welding applications. See Figure 45.
After entering the table setup information and selecting the green
continue icon, the screen will display a representation of the table
setup and the status of the necessary connected devices. A green
checkmark will indicate a properly connected device and a red X will
indicate a disconnected device. See Figures 46 and 47.
OPERATION (USER MODE)