VRTEX
360+, VRTEX
360, VRTEX
®
®
USER MODE
SYSTEM SETUP INFORMATION
When setting up the virtual equipment, the user must set the welding
parameters (e.g. wire feed speed for VR GMAW) within the ranges
set in the tolerance editor. The system ships with Lincoln default
tolerances. Lincoln default tolerances can be reviewed in the
tolerance editor or in the WPS manual.
However, users can set and use their own tolerances for teaching
beginner welders. The tolerances also determine how the user is
scored on such parameters as work angle, travel angle, travel speed,
position and contact tip to work distance or arc length. See the
Tolerance Editor section for more details.
MEASUREMENT UNITS
Coupon Thickness
Gas Flow Rate
Wire Feed Speed
Weldometer - Base Metal
Weldometer - Gas
Weldometer - Consumables
TRANSPORT
®
Table 1 – Measurement units
Imperial
Abbrev.
in.
inches
CFM
cubic feet per minute
IPM
inches per minute
lbs
pounds
CF
cubic feet
lbs
pounds
20
LOGIN SCREEN
OVERVIEW
This page allows the user to: (See Figure 41)
• Enter Username
• Select Language Preference (Orange Icon)
• Select Imperial or Metric Units (Blue Icon) - See Table 1 for details
• Shutdown System (Red Icon)
• Continue to the next Setup Screen (Green Icon)
• Select Theory (Yellow Icon)
Figure 41 – Login screen
Details
Abbrev.
OPERATION (USER MODE)
Metric
Details
mm
millimeters
LPM
liters per minute
MPM
meters per minute
kg
kilograms
L
liters
kg
kilograms