Hardware Uncrating - Lincoln Electric VRTEX 360+ Operator's Manual

VRTEX 360+, VRTEX 360, VRTEX
® ®
Figure 16 – Swing arm rotation
TABLE
The table can be used to gain stability and learn proper body
positioning. The base supports the stand and has weights on the
back to maintain stability. The table can be swung out of the way
when not in use. The table also has storage compartment for the
coupons.
CAUTION
Do not use the Stand/Table without the base counter
weights properly positioned.

HARDWARE UNCRATING

TOOLS NEEDED
A utility knife is the only tool needed for uncrating of the VRTEX
machine.
1. Using a utility knife, carefully remove the two plastic bands
securing the carton to the skid. See Figure 17.
2. Carefully lift the carton off of the machine. See Figure 17.
Figure 17 – Plastic band and carton
CARTON
TRANSPORT
®
PLASTIC
BANDS
14
3. Using a utility knife, carefully remove the three plastic bands
securing the machine to the skid. See Figure 18.
Figure 18 – Plastic bands
4. Unlock the front caster brakes by lifting the tabs into the upright
position. See Figure 19.
Figure 19 – Unlock front caster brakes
UNLOCKED
5. Using two people, carefully lift and roll the machine off of the skid
and place in the desired work space. See Figure 20.
Figure 20 – Remove from skid
INSTALLATION
PLASTIC
BANDS
LOCKED
SKID