Lincoln Electric VRTEX 360+ Operator's Manual page 19

VRTEX 360+, VRTEX 360, VRTEX
® ®
UNIGUN DEVICE - VRTEX TRANSPORT ONLY
The Unigun device contains a swappable head to allow switching
between GMAW, GTAW and SMAW. The GMAW configuration has a
trigger that is used during the simulation to initiate and maintain the
simulated welding arc. The SMAW configuration has a stationary rod
that represents a stick electrode. This rod will appear and decrease
in length when welding in the virtual environment.
Figure 9 – Unigun device
HELMET
HEAD SIZE ADJUSTMENT: HEADGEAR TIGHTNESS is
adjusted by pushing in the Ratchet Knob and turning to adjust for the
desired head size. This knob is located at the back of the helmet.
NOTE: Polyethylene foam pipe insulation may be used to
accommodate smaller head sizes.
HEADGEAR CROWN ADJUSTMENT is made by adjusting
for comfort and snapping the pin into the hole to lock securely in
place.
Figure 10 – Helmet adjustment
Tilt
Crown
Adjustment
Tilt
Adjustment
Fore-Aft
Adjustment
TILT: Tilt adjustment is located on right side of helmet. Loosen the
right headgear tension knob and push the top end of the adjustment
lever outward until the lever's Stop Tab clears the notches. Then
rotate the lever forward or back to the desired tilt position. The Stop
will automatically engage again when released locking the helmet
into position.
TRANSPORT
®
Lenses
Ratchet Knob
Push In
FORE / AFT ADJUSTMENT: Adjusts the distance between
the FMD and the front of the helmet. To adjust, loosen the outside
tension knobs and slide forward or back to desired position and
re-tighten.
NOTE: Make sure both sides are equally positioned for proper
operation.
The helmet has an FMD (Face Mounted Display) on the inside. These
FMD lenses display the virtual environment to the user. Each lens can
be shifted left or right to align with the users eyes by applying gentle
pressure. In addition, the lenses can be lifted up and down as well
as shifted forward and back for the best fit. The user should make
sure the lenses are parallel to their eyes. Keep the lenses clean at all
times. See the Maintenance Section.
Figure 11 – Helmet lenses*
LENSES
COUPON COMPARTMENT
The coupon compartment, in the stand, houses the physical coupons.
When not in use, the coupons should be stored in the compartment
and/or in the front storage drawer. Each coupon fits in its own area
defined by the foam located in the compartment.
Figure 12 – Coupon compartment
12
INSTALLATION
*Condensation on lenses may
appear in high humidity enviroment.
Run FMD for approximately 10
minutes to clear up moisture from
the lenses.