Installation On A Din Rail - Siemens SCALANCE X-200 Operating Instructions Manual

Installation

4.3 Installation on a DIN rail

4.3 Installation on a DIN rail
Installation
Figure 4-1
To install an X-200 on a 35 mm DIN rail complying with DIN EN 60715, follow the steps
below:
1. Fit the middle locking mechanism of the device on to the DIN rail.
2. Press the device down against the DIN rail until it locks into place.
3. Fit the connectors for the power supply.
4. Fit the connectors for the signaling contact
5. Insert the terminal blocks or M12 cable connectors into the sockets on the device.
Removal
To remove an X-200 from a DIN rail, follow the steps below:
1. First disconnect all connected cables.
2. Use a screwdriver to release the lower DIN rail catch of the device and pull the lower part
of the device away from the rail.
48
Installation on a 35 mm DIN rail
Operating Instructions, 02/2018, C79000-G8976-C284-12
SCALANCE X-200