Table of Contents
Advertisement
5.3
Installation on a DIN rail
Mounting
To install the device on a 35 mm DIN rail complying with DIN EN 50022, follow the steps below:
1. Place the second housing guide of the device on the top edge of the DIN rail.
2. Press the device down against the DIN rail until the spring catch locks in place.
3. Fit the connectors for the power supply. See also section "Power supply (Page 29)".
4. Insert the terminal block into the sockets on the device.
Figure 5-1
Installation on a 35 mm DIN rail
Removal
To remove the device from the DIN rail, follow the steps below:
1. Disconnect all connected cables.
2. Pull out the terminal block for the power supply.
SCALANCE X-000
Operating Instructions, 12/2018, C79000-G8976-C344-03
Mounting
5.3 Installation on a DIN rail
23
Advertisement
Table of Contents
