Operation; Important Operation Notifications; Warnings (Yellow); Alarms (Orange) - ATS Pyro-Clean Instruction Manual

F. Operation
F.1 Important Operation Notifications
There are several notifications that may appear when operation of the Pyrolytic Oven is initiated. These are broken
into three categories of severity: warnings, alarms, and faults. DO NOT IMMEDIATELY SHUT THE MACHINE
DOWN WHEN THESE NOTIFICATIONS APPEAR. Allow unit to continue cycle to completion. If the unit is required
to shut down, it will do so on its own.
Warnings, alarms, and faults are color coded in yellow, orange, and red. Refer to the list below for descriptions of
these common operation notifications. If additional assistance is required, contact the ATS Service Department at
+1-724-283-1212.

Warnings (Yellow)

These do not stop the cycle but are things that you may wish to check after it is complete. Do not shut the machine
down if these appear. They may indicate:
• 6 Month Clean Warning
• 1 Year Catalyst Replacement Warning
• Low Draft Warning

Alarms (Orange)

These do not stop the cycle but are things that should be checked before next cycle. Do not shut the machine down
if these appear. They may indicate:
• Low Draft Alarm

Faults (Red)

These are faults that will automatically stop the current cycle. They must be fixed before next cycle.
• Oven Chamber Over-Temp
• Oxidizer Chamber Over-Temp
• Oven Chamber Over-Press
• Standardization Error
• Door Lock did not Engage
• Draft Inducer Error
• Low Draft Fault
F.2 Initial Start-Up: Empty Load
Do not operate the oven with a load if the correct, slight negative draft/pressure in the oven chamber is not
achieved. Refer to Installation Instructions or call the ATS Service Department at +1-724-283-1212 for technical
assistance.
26 MAN - Pyrolytic Oven - REV: Original | F. Operation