Led Indicators - Atlona Omega AT-OME-EX-KIT Installation Manual

LED Indicators

The PWR and LINK LED indicator on both the transmitter and receiver unit provides basic
information on the current status of the AT-OME-EX-KIT. The information in the table below
applies to both the transmitter and receiver unit.
PWR
Solid green
Off
LINK
Solid yellow
Blinking yellow
Off
Description
Unit is powered.
Unit is not powered.
• Verify that the locking connector is securely fastened to the
power receptacle.
• Make sure that the power supply is connected to an active
AC outlet.
Description
The link integrity between the transmitter and the receiver is
good.
Poor signal integrity between the transmitter and the receiver.
• Make sure that the category cable between the HDBaseT
IN port on the transmitter and the HDBaseT OUT port on
the receiver is secure.
• The category cable may be compromised. Try using a
different category cable. Make sure that the cable is solid
core. Stranded or patch cables are not recommended.
The link integrity between the transmitter and the receiver is
compromised.
• Check the category cable between the HDBaseT IN port
on the transmitter and the HDBaseT OUT port on the
receiver.
7
Installation Guide
AT-OME-EX-KIT