Leakwise ID-220 SERIES User Manual page 24

The system is supplied in Common mode for systems supplied with a single sensor, and in
Individual mode for systems supplied with more than one sensor. In order to change between
modes, if required, do the following:
1. Remove the existing Lights board from the front panel.
2. Remove the aluminum black Lights panel.
3. Install the black Lights panel inverted with the correct legends facing the user.
4. Install another Lights board (DWG S SLC 003 1) that has correct LEDs colors for the
required mode (should be ordered separately). The serial number of a Common mode
board end with a "C", while the serial number of an Individual mode board end with a "I".
5. Make the correct mode setting in SLC-220 Settings (chapter 4.5).
SLC-220 User Guide Rev 2.0
Lights Board picture:
24
June 2018