Connecting The Relay Outputs - Leakwise ID-220 SERIES User Manual

19
Arranging the wires:
For SLC-220/Multi, there is one white plastic wire saddle below each Outputs board. Insert the
wires into the saddles and guide them to the left of the enclosure, then down and to the cable
gland.
Note: If there is only one Outputs board and more than one sensor, and the Common functionality
of the Outputs board is selected by setup, then the Analog output will be associated with
sensor#1.
Note: For a disabled sensor associated with an Outputs board, the 4-20mA output will default to
4.33 mA.

2.2.4 Connecting the Relay Outputs

Up to four Outputs boards may be installed in one SLC-220/Multi. The first board, located
rightmost, is normally associated with sensor #1; the second board from the right is normally
associated to sensor #2, etc. (See note 3 in 2.2.5 for exceptions).
SLC-220 User Guide Rev 2.0 June 2018