Using With The Alkaline Battery; Im-Dr580H - Sharp TINSE0568AWZZ Operation Manual

Using with the Rechargeable

IM-DR580H

Battery (continued)
" Checking the remaining amount of battery
level
The remaining amount of battery level is shown by the
battery indicator ( ) during operation.
<On the remote control>
! When the battery is completely discharged, the battery
indicator will flash. Recharge the battery or replace the
alkaline battery with a new one.
! When the battery has run out completely, "LoBATT"
will appear. Then, the power will be disconnected
automatically.
Notes:
! If you use the battery which you stopped charging
halfway, " " may appear. It does not mean that the
battery is completely charged.
! The battery indicator will not correctly display the
remaining capacity for approximately 20 seconds after
the power has been turned on.
! When the AC adaptor is used, the battery indicator will
not be shown.
! The number of bars shown in the battery indicator may
increase or decrease, depending on the operation
being performed. This is normal.
16
IM-DR580H(E) TINSE0568AWZZ
Using with the Alkaline
Battery
Use one commercially available alkaline battery (LR6,
"AA" size).
The rechargeable battery can be used at the same time.
2 Open
1
Press
Back of the
portable MD
RELEASE LOCK
1
Open the case cover.
2
Insert an alkaline battery into the battery case.
Set the battery properly according to
the case.
3
Attach the battery case to the portable MD.
03/10/15 IM-DR580H(E)2.fm
and inside