Function Of Remote Control 16; How To Use Ventilation Function - KDK 30BGCH Installation And Operating Instructions Manual

FUNCTION OF REMOTE CONTROL
Notice
提示事項
1. When the heating mode or hot drying mode is switched to the air ventilation mode, the fan
blade will run at a low speed for 20 seconds to cool the heater down, then enter the air
ventilation mode.
從"暖氣"或"熱乾燥"模式切換到換氣時，為使加熱器冷卻，扇葉將以低速運轉20秒後切換到換氣。
2. When you use the mode button on the mode button panel on main body, then press the
button on remote control, the status displayed by the remote control may different from the
actual product status.
當操作了機體模式按鈕面板上的模式按鈕後，再按遙控器上的
狀態可能會不一致。
3. If there is no sound from product after you press the remote control, it means the product does
not receive the remote control signal, you need to reoperate.
使用遙控器操作後，產品沒有提示音，則表示產品沒有接收到遙控器的信號，需要重新操作。
4. Please remove the protective film on the remote control before use.
使用前請將遙控器上的保護膜撕掉。

HOW TO USE VENTILATION FUNCTION

Used to ventilate the bathroom
1
Press the button to start the air change mode.
按 按鈕，換氣模式開始運轉。
The indicators of VENT. and default setting time (15 MIN.) light
on, then turn off automatically after 3 seconds.
VENT的指示燈和初始設置時間(15 MIN.)的指示燈亮，3秒鐘後指示燈
自動熄滅。
2
During operation, you can press
time.
運轉過程中，可通過
3 To confirm the current running mode and remaining time for
reference, press the
如需 確認 當 前運 轉模式及參考剩餘時間請按
4 This product will stop automatically when the set time is up.
運轉 完 所設 置時 間後，本機會自動停止。
5
To stop midway in operation, press the
如需在運轉途中停止，請按
遙控器 功 能 介 紹
按鈕，遙控器所顯示的狀態與產品實際
換 氣 功 能的使用方 法
浴室 換 氣時使 用
to change the running
按鈕，調整運轉時間。
button.
按鈕。
button.
按鈕。
17