Test Run 14; Function Of Remote Control - KDK 23BWDBH Installation And Operating Instructions Manual

Thermo ventilator
Table of Contents

Advertisement

TEST RUN
Does it blow out hot air?
是 否有熱 風 輸出?
The remote control must be paired with the product before use. Within one minute
after the product is powered on, press and hold the buttons
control for 3 seconds to complete the pairing process. When the pairing is
successful, three beeps will be heard. (If the remote control was just replaced,
power off and restart the product and then repeat the above pairing procedure.)
遙 控器 需 要對碼 才 能使用 , 在產品 通 電1分 鐘 內, 同 時長按3秒遙控 器
產 品對 碼 ,對碼 成 功後會 有3聲蜂 鳴 聲響起 。(如 更換遙 控 器, 產 品需斷 電 重新啟 動 ,并重 複
上 述對 碼 步驟。)
※ When two or more thermo ventilators of the same model are installed in the nearby
area, the RF remote control may be paired with more than one thermo ventilator at
the same time. Therefore, please make sure that each thermo ventilator is installed
with an independent "omnipolar power switch" according to the requirements and
check that only one thermo ventilator is powered on for each pairing.
當 附近區 域 安裝有2台或 以 上相同 型 號的浴 室 換氣暖 風 機時, 使 用遙控 器實施 對 碼操作 , 其可能
會 與2台 或 以上 相 同型號 的 暖風機 同 時對碼 , 影響使 用 ,所以 請 務必按 照要求 , 為每台 暖 風機安
裝 獨立的 " 電源全 極 開關" ,並確 保 只通電1台暖風 機 進行對 碼 。

FUNCTION OF REMOTE CONTROL

STANDBY button
待機按鈕
In the standby status,
this product still requires
power consumption. If
the product will not be
in use for a long time,
the all-pole power
switch should be turned
off to disconnect the
power supply for the
purpose of energy
saving.
本產品處於待機狀態時,仍
有功耗。如長時間不使用時,
應使用電源全極開關斷開電
源,以節省能源。
TIMER button
定時按鈕
Timer function
定時功能
Notice
提示事項
When using heating function for a while, press the
The fan will stop running after a delay of 10 seconds.
當使用加熱器功能一定時間後,按
Iseach button on remote control perform
its right function?
遙 控器上 的 各個功 能 按鈕的 功 能是否 正 常?
按鈕,加熱器將先停止工作,扇葉延時10秒後再停止工作。
+
+
遙控器 功 能
HEAT button
Heating function
取暖功能
VENT button
Air change function
換氣功能
DRY COOL button
DRY COOL function
涼乾燥功能
DRY HOT button
DRY HOT function
熱乾燥功能
SWING button
風向按鈕
The function of
air direction
adjustment
風向調節功能
button to stop the heater.
試運 轉
on the remote
按 鍵, 完 成
取暖按鈕
換氣按鈕
涼乾燥按鈕
熱乾燥按鈕
15

Advertisement

Table of Contents
loading

Table of Contents