KDK 30BGCH Installation And Operating Instructions Manual page 10

HOW TO INSTALL
3
Connecting the duct pipe
4.Duct Pipe Connection on P.14.
連接 管 道 。
4
Push the main body upward into the ceiling board
and wooden frame by closely leaning against the
adapter, clip the clipping position of the adapter
into the Locating slot of the main body (otherwise,
may have air leakage), and fix the main body with
four 4 x 20 self- tapping screws.
將機體緊靠出風口接頭往上推入天花板與木框，並使出風
口接頭卡位卡入機體固定槽(否則漏風)，用 顆
自攻螺絲將機體牢固地固定。
Notice
提示事 項
Please be careful not to pinch the cord, when push
upward the main body.
推 入 機 體 時 請 注 意不 要 夾傷 線。
，
5 Use one 4 x 20 self-tapping screw to fix the
adapter. Be sure to fix this screw because it
can prevent the main body from falling off the
ceiling board.
用 顆 1 4x20 的自攻螺絲將機體牢固地固定
此 螺絲 能 起 到 防 止 機體 脫落 的作 用， 請務 必安 裝
6
After completion of the installation work, be
sure the condition between the main body and
the adapter is proper. It can be checked from
the inspection hole.
安裝完成後，請務必從點檢口確認機體與出風口接頭
的安裝是否到位。
Notice
提示事項
If adapter fails to cling to the main body, it
may cause air leakage.
如機 體 與 出 風 口 接 頭未 貼緊 ，會 導致 漏風
2 Main body installation
Method 2 Ordinary ceiling mounting
Open a 300 mm x300 mm mounting hole in the ceiling board.
在天花板上開一個300 mm x300 mm的 安裝 孔。
10
Refer to Section
參考第14頁 4.管道的連接
4 4x20 的
Cross screwdriver
，
。
(not longer than 150 mm)
十字螺絲刀
(長度不大於150 mm)
。
機體的安裝
方法二 普通天花板吊裝
Ceiling board
天花板
Clipping position
of the adapter
出風口接頭卡位
Self-tapping
screws
4 x 20 (4 pcs)
自攻螺絲
4x20(4 )
Self-tapping
screws
自攻螺絲
No buckled
Buckled
卡到位 未卡到位
Unit:mm
單位：mm
安裝方法
Locating slot
of the main
body
機體固定槽
顆
4 x20
4x20