Messages And Signals - Sharp UX-5000 Facsimile Operation Manual

DD <P=001>
Display messages
CHECK XXXX (paper source)
CONF REFUSED
CONF. RX ERROR
COVER OPEN
DRUM LIFE OVER
FAX RCVD IN MEMORY
FUNCTION MODE
LINE ERROR
MEMORY FULL
NO CONF. FUNC
NO PAPER
NO RELAY FUNC

MESSAGES AND SIGNALS

Either or both of the paper sources (the cassette or tray) will
appear in place of "XXXX". This indicates that the paper
source is not properly installed in the machine, or a paper jam
has occurred in that source.
A confidential transmission has been denied because you
entered an incorrect mailbox number for a machine with
mailboxes.
Confidential reception was cancelled because the mailbox
number specified by the transmitting machine is not
programmed in your fax.
The operation panel is open. Close it.
The drum cartridge must be replaced.
A fax has been received in memory because the toner
cartridge needs replacement, you have run out of printing
paper, or the paper is jammed. The fax will automatically print
out when the problem is fixed.
The FUNCTION key has been pressed.
Transmission or reception was not successful. Press STOP to
clear the message, and then try again.
The memory is full. See "Dual access" in "Sending
Documents" in Chapter 3.
Confidential transmission was cancelled because the receiving
machine does not have a confidential function, a confidential
passcode is not programmed in it, its memory is full, or it is not
a Sharp model.
This message will be followed by one of the paper sources in
parentheses, and informs you that the paper source is out of
paper. If no paper source is indicated, both paper sources are
out of paper.
A relay request has been denied because the other machine
does not have a relay broadcast function, its memory is full, or
it is not a Sharp machine.
TROUBLESHOOTING
UX5000U-TSDM
8-3