Messages And Signals - Sharp AM-400 Online Manual

Messages and Signals

Display messages
ADD PAPER
BYPASS MISFEED
BYPASS PAPER! /
IF COPY, PRESS
(alternating messages)
CHK SCANNER LOCK /
PLS RETURN POWER
(alternating messages)
COVER OPEN
DATE/TIME UNSET
DOCUMENT JAMMED
DOCUMENT READY
Check the printing paper. If the tray is empty, add
paper. If there is paper in the tray, make sure it is
inserted correctly (take out the stack, align the edges
evenly, and then reinsert it in the tray). Printing will
resume automatically when the output tray is
replaced.
The paper is not inserted correctly in the bypass tray.
Remove the paper and insert it again.
Paper has been inserted in the bypass tray. If the
paper has been inserted for a copy job, press
set the paper size. If the paper is for a print job, the
message can be disregarded.
Make sure that the scanner lock has been released
(see page 13) and then unplug the power cord, wait
at least 5 seconds, and plug it back in.
One or both of the print compartment covers are
open. Make sure both covers are closed.
The date and time need to be set (see page 46). Note
that the date and time settings will be lost if the
machine is unplugged or a power failure occurs.
The original document is jammed. See the following
section, Clearing Paper Jams. Document jams will
occur if you load more than 20 pages at once or load
documents that are too thick (see page 62). The
document may also jam if the receiving machine
doesn't respond properly when you attempt to send a
fax.
A document has been inserted in the auto document
feeder and the machine is waiting for you to begin
faxing or copying.
Messages and Signals
A
to
145