Entering Your Name And Fax Number - Sharp UX-5000 Facsimile Operation Manual

RT <P=001>

ENTERING YOUR NAME AND FAX NUMBER

To have your name and fax/telephone number (called the "Sender's name" and
"Sender's number") printed at the top of every page you transmit, program them by
pressing the panel keys as shown below.
You must program your name and fax number in order to comply with the
Consumer Protection Act of 1991 (see inside of front cover).
If you enter an incorrect number or letter, flip the Rapid Key overlay up (if it is
down), press the " " key to move the cursor back to the mistake, and then enter
the correct number or letter. (To move the cursor forward, press the " " key.)
Note:
The fax will not respond if you press the FUNCTION key while the display shows the
telephone line status. Before performing any operations requiring the FUNCTION key,
make sure the display shows the date and time (press the CHANGEOVER key to
switch between the telephone line status and the date and time).
Step Press these keys:
FUNCTION
1
2
5
3
3
4
S
5
6
STOP
7
2-4
Comments
3
"ENTRY MODE" will appear in the display.
"OWN PASSCODE SET" will appear in the
display. Note that instead of pressing "3", you
can press "#" or "
3
settings in ENTRY MODE until "OWN
PASSCODE SET" appears, and then press the
START key to select it.
Enter your fax number (max. of 20 digits) by
1
2 3 4 5
pressing the numeric keys. (To insert a space
between digits, press the "#" key. To insert a "+",
(Example)
press the "
START
Flip the Rapid Key overlay down (if it is up), and
P
A R
H
enter your name by pressing the appropriate
keys as shown on the following page.
(Example: "SHARP")
(Maximum of 24 characters.)
START
STOP
Press the STOP key twice to return to the date
and time display.
INITIAL SETTINGS
UX5000U-IPSN
*
" to scroll through the
*
" key.)