Assembly Of Switch Car - FlowLine Smart-Trak AV23 Series Manual

Installation (continued)
SENSOR CAR AND BAYONET ADAPTER:
The sensor car assembly is the heart of the Smart Trak™ system. It slides in the grooves of the track, and is
locked into position by a plastic bolt and screw. The bayonet to 3/4" NPT adapter has a female 3/4" NPT fitting
on one end where the sensor (not included) will screw in, and a bayonet fitting on the other end that attaches it
onto the sensor car with a slight turn, with an O-ring in-between to provide tension for the push-and-turn
connection.
Switch Car Kit Assembly Drawing (Side View)
Switch Car Kit to Smart Trak™ (Top View)
DETERMINE THE PROPER WIRE LENGTH:
Don't make the mistake of trimming the sensor wires too short before the process is tested. If the sensors
might need to be lowered in the future, leave sufficient slack in the wires to allow for future adjustment. This
extra wire may be stored in the bottom of the terminal strip housing, or elsewhere above the compression
fitting.
| 16
Inventory:
One switch car kit (LM30-1001) consists of the
following parts:
1 x Locking bolt
1 x Locking Nut
1 x Sensor car
1 x O-ring
1 x Bayonet to 3/4" NPT adapter
Switch Car Kit to Smart Trak™
(Side View)
Step Seven
LM900006 Rev 0_3