FAN FILTER UNIT
INSTALLATION & SERVICE INSTRUCTIONS
Speed Controllers
PSCSC/WK Speed Controller Installation & Operation
Sample line string:
FFU-1-X//I/24/48/BTR/FC/PSC/115/10////HEPA//PSCSC//WK-PSC//DSW-115////TMB/ASSP//////WPFH/PL-AL///PL-B12/
If unit does not have the wall kit (WK) option, proceed to step 11A.
Sample line string:
FFU-1-X//I/24/48/BTR/FC/PSC/115/10////HEPA//PSCSC/////DSW-115////TMB/ASSP//////WPFH/PL-AL///PL-B12/
STEP 8A: Locate pre-installed electric box for wall-mounted speed controller.
STEP 9A: Wire speed controller according to wiring diagram found on page 57. Wall-mounted speed controller will be wired in
series with the motor.
NOTE:
Wiring should be carried out by a certified electrician and meet national and local electrical codes.
STEP 10A: Attach the wall-mounted controls faceplate to the electrical box using the screws provided.
STEP 11A: Wire the unit according to appropriate wiring diagram. If Power Cord (PC) option is selected, simply insert plug end
into electrical socket.
Sample line string:
FFU-1-X//I/24/48/BTR/FC/PSC/115/10////HEPA//PSCSC/////DSW-115/PC-115///TMB/ASSP//////WPFH/PL-AL///PL-B12/
NOTE:
Wiring should be carried out by a certified electrician and meet national and local electrical codes.
STEP 12A: If using RSR filter, refer to page 11 for filter installation instructions.
NOTE:
Ensure that the space is clean, free of debris, and ducts are cleaned and ready for operation prior to installation of filter.
STEP 13A: Ensure proper voltage is hooked up to the unit.
STEP 14A: Proceed to controls and balancing section on page 42.
Clockwise rotation will increase airflow, counter-clockwise rotation will decrease airflow.
NOTE:
NOTE:
If unit is ducted, refer to Technical Note: Balancing Ducted Units on page 44 of this manual.
6
FAN FILTER UNIT - Manual | priceindustries.com
FIGURE 3: PSC SPEED CONTROLLER WITH WALL KIT OPTION