Price FFU series Installation And Service Manual page 23

FAN FILTER UNIT
INSTALLATION & SERVICE INSTRUCTIONS
STEP 7: With two (2) people holding the unit, pull cable back through plenum until plenum can rest on top of filter.
STEP 8: Refer to BTR Filter Instructions found on page 13 for proper filter installation.
STEP 9: Refer to wiring diagram (located in control box) to connect LED leads to terminal block.
NOTE: If unit has BFC speed controller, LED leads will need to be connected to the BFC controller instead of the terminal block.
Calibration
All pressure transducers are factory calibrated. If a different pressure transducer set point is desired, refer to page 17.
FIGURE 16: THREADED STANDOFF THROUGH FILTER
CHANNEL.
FIGURE 17: CABLE ASSEMBLY.
priceindustries.com | FAN FILTER UNIT - Manual
21