Siemens SITRANS F Operating Instructions Manual page 25

Press the <Down> arrow to select Install Completed?, then press the <Right> arrow.
Use the <UP> or <Down> arrows to move the cursor to Install.
Press the <ENT> key to register selection. The meter will then perform an Initial Makeup,
which conditions its operation to the selected transducer, pipe, and liquid. It then auto-
matically sets the empty pipe and zero flow levels. Be patient, this process may take
several minutes.
Upon completion the meter reports the measured liquid sonic velocity. To accept the
Measured Vs, press the <Down> arrow.
NOTE: If you want to correct the reported sound velocity, press the <Right> arrow to
edit the indicated Vs value, then press <ENT> to continue.
NOTE: The meter will now perform an AutoZero operation where the meter measures
any zero flow offset, which is used to correct the flow reading.
Siemens Site
Key [Install] after mounting transducers
Transducer P/N
Install Completed?
Empty Pipe Set
Zero Flow Adjust
Pick/Install Xdcr
Siemens Site
Drive 10 m 13
Transducer P/N
Install Completed?
Empty Pipe Set
Measured Vs m/s
Zero Flow Adjust
1490
Not Setup
Pick/Install Xdcr
Siemens Site [1]
Set Empty Pipe Detection Threshold
Transducer P/N
Install Completed?
Empty Pipe Set
Zero Flow Adjust
Pick/Install Xdcr
[1] SITE1
1011AP-16S2-B
No
*Install
Chan Not Setup
Chan Not Setup
[1] SITE1
[6:----------:0]
1011AP-16S2-B
Install
Chan Not Setup
Chan
SITE1
1011AP-16S2-B
Yes
MTYmatic
Actual Zero
5