Table of Contents
Advertisement
i. Blower(s) and agitator are activated in this setting. Note that the blower needs
Please note the following:
BLOWER must be running for the agitator to operate.
To obtain maximum blower output, ensure that:
VARIABLE SPEED is in the off position, and
AUXILIARY BLOWER is in the ON position.
3. Load Insulation -- Remove packaging material from around insulation and load into hopper.
Reprogramming Intec's Long Range Transmission wireless remote
Transmitter
1. Get to the underside of transmitter.
a. Transmitter may be in jacket that allows for fitting onto arm or hose. You may desire to
remove transmitter from jacket.
b. Remove small piece of black tape on back of transmitter.
c. Stick a paperclip into the small hole and hold button down for 7 to 14 seconds to enable
wireless transmitter to select a diffent chanel.
Receiver
1. Ensure HONDA motor is running at full throttle.
2. Rotate the ROTARY CONTROL SELECTOR SWITCH to the WIRELESS selection.
a. Note: The LEARN BUTTON LED light will flash steadily, while the SYNC-LED will not be lit.
3. Press the LEARN BUTTON and release.
a. the SYNC-LED will flash rapidly, while the LEARN BUTTON LED light will remain solid.
4. On the wireless remote transmitter:
a. Press and release the BLOWER button
b. Press and release the AGITATOR button
5. Wait 17 seconds for the receiver to reset.
6. When the receiver has been reset, the LEARN BUTTON LED light will flash steadily, while the
SYNC-LED will not be lit. COMPLETE – The wireless receiver has now been programmed to
accept the transmitter's signal.
T: 303-833-6644
Original Language - English
to be on for the agitator to come on.
800-666-1611
or
Instruction Manual
www.inteccorp.com
|
10
Advertisement
Table of Contents
